This attachment is tough. If it can cut concrete, then obviously it doesn’t worry about ripping apart lesser products.

Designed and Developed by a company with over 30 years of contract profiling experience, the RM150 Profiler’s solid framework and fluid dynamic design make this profiler a stable cutting device.

Basically this is a wheel with teeth on it that rotates and rips into the surface. Two levelling rams give the operator a high degree of accuracy in cutting depth and cross slope control. So it can cut a trench 150mm wide and up to 100mm deep in concrete and any lesser surface.

Additionally, it can be used to cut a slope on concrete, or taper an edge. The possibilities are endless. This is a true demolition tool.

It has a dust suppression system that includes water tanks, pumps and nozzles. As well as suppressing dust, the water cools the cutting teeth.

This increases tooth life ten fold, as well as keeps the cutting teeth sharp. The water tanks are easily removable and refillable, increasing versatility on site.