Do you have a need to put a fence across a concrete area and don’t know how to dig the holes? Or do you want to set a post through the concrete in the middle of your shed? Or just dig a hole in hard rock?

The Dingo can do it. You just need the Rear Mounted Corer attachment

Core drills have been available for a long time. But the power of Dingo has not been available to run them…until now. Because of the size, weight and manuvorability of the Dingo K9-4, (now with additional hydraulic outlets), we were able to adapt to run these drills. The Dingo’s unique hydraulic speed control, together with the added stability of being bolted to the Dingo, allows you to run all sizes of core drill up to 400mm and because extensions are available, we are sure you will get to any reasonable depth.

It is best to run a large quantity of water so a hose fitting is on the water adaptor that floods the water down the centre to where it is needed. However, if hose volume is not available, we can run a water pump as well, from any supply.

So next time you need some impossible holes dug, just bolt on your Rear Mounted Corer. And because it bolts on the back of the Dingo, after you take the hard core out, you just turn around and dig the dirt out through the cored hole with your standard posthole digger, which is hanging on the front. You don’t even have to change attachments.

FACTS AT A GLANCE | Rear Mounted Corer
Stroke:	600mm
Drill Size:	80-400mm
Drill Depth:	400mm standard
	Deeper with longer drills
Hydraulic Motor:	29 cu in
Weight:	220kg
Used For:	Drilling holes in cement, rock, etc.
Used By:	Fencers, Builders, Soil Testers, Miners and Contractors